The 105 Year Anniversary Edition of harley-davidson Softail

奔奔

mike 讲了一大堆，我也没实际操作过，我都听朦了！

You have an oil tank behind the engine so this is what you do:（你的引擎背后有一个邮箱，所以你是怎么做的？）
1) run the engine until it is hot （运转引擎直到发热）
2) Drain the oil from the oil tank only, there is a hose that runs from the oil tank to the bottom of the motorcycle. remove the plug at the end of this hose and the oil will drain from the tank
（从油箱排出油，有一个软管从摩托车的油箱底部穿过，拔出该软管插头，油就会从油箱流出）
3) While the oil tank is draining change the oil filter at the front of the engine
（直到油排出，更换在发动机前面的机油滤清器）
4) Once all the oil is drained and the filter is replaced, refill the oil tank unitl the proper level is achieved.
（一旦所有的油排完并更换机油滤清器后，填充油箱直到适当的水平）
5) check the oil level on the dipstick with a HOT ENGINE ONLY, while the bike is on the sidestand
（一定要在机油热的时候检查量油尺确定机油水平，让车维持在正确的标准内）
6) make sure you have the correct oil level, 3-4 quarts ( 2-3.5 liters). and you are done!
（请确保您有正确的油位，3-4石英（2-3.5升），你就完成啦）

热情的Mike还发了该车的Maintenance manual：https://docs.google.com/viewer?a ... oXTgqLQ6lbigdSyYlxA


#19 = dipstick（量油尺）
#20 = oil drain hose（放油软管）
#26 = oil drain bolt - remove this bolt and oil will come out.  Engine must be HOT.（放油螺丝，旋出此螺丝机油就会流出来，引擎必须是热的）

奔奔

大耶，看到了木有，放油螺丝是在那该死的软管上的，估计没人会晓得螺丝在那吧！呵呵~~你试试看咯~~~

头大

OK 替我谢谢他！