After 2008 Buell XBseries TPS reset 节气门角度重置

奔奔

原文：
According to the Service Manual, with the '08 models the TPS resetting is accomplished without the need for a plug-in diagnostic tool:

Have the Run/Stop button set to Run.
Turn the ignition key to the On position but do not crank or start the engine.
Open the throttle fully to the stop and hold it there for one second.
Close the throttle fully to the stop and hold it there for one second.
Repeat the throttle open/close procedure a total of three times in succession.
Turn the ignition key to Off/On/Off/On/Off in succession to complete the procedure.


据服务手册，'08后的TPS复位，不需要任何的诊断工具就能完成的：
步骤：

1、运行/停止按钮设置为运行。（也就是引擎死活开关）
2、将钥匙点火开关旋到“开”的位置，但不启动发动机。
3、打开油门完全停止，并保持一秒钟。
4、关闭油门完全停止，并保持一秒钟。
5、连续三次重复节气门的打开/关闭的过程。（也就是重复以上步骤3次）
6、转动点火钥匙关/开/关/开/关连续这几个动作过程后结束。

做完这些动作后TPS就重置了，接下来紧记 骑车出去慢给油1500转保持500米 2500转保持2公里 3500转保持5公里  然后任何转速上急慢速混合跑个30公里 电脑就全部磨合完成了！
你的buell低转发吐发顿的问题就完全解决了！
我的把这个赶紧记下来 万一以后我又给忘记了

zalajon

神谢

骗银地

奔奔

补充
quote:
1. Turn on the key.
2. Set the kill switch to the run position.
3. Don't start the engine. Rotate the throttle from fully closed (gently held closed) to fully
open (gently held open), and then back again to closed (gently held closed).
4. Repeat 3 times. Hold at each stop (fully open, fully closed) for 1 full second.
5. Turn the key off and back on.
6. If you connect to Directlink, a fully closed throttle should indicate between 3.7 to 4.2 degrees. If it
doesn't, repeat the above steps.

奔奔

Manual TPS Reset
1. Repeat three times:
a, Turn the ignition switch from Off to ON.
b. Roll the Throttle wide open and hold for one second.
c. Close the throttle and hold for one second.
d. Turn the ignition switch off.